How to use argon arc tester

How to use the argon arc tester is as follows:

1. Turn on the power and wait until the temperature and humidity display are stable before starting the test.

2. After entering the computer interface, select the specimen specification according to the specimen size.

3. During the test, the thermocouple and the heating tube power contactor of the spray and rain test are heated according to the set program. After reaching the set value, the test cycle automatically counts down.

4. After the blowtorch combustion test starts, when smoke is discharged from the flue, the smoke exhaust system should be started.

5. Before the end of the test period, the temperature or humidity in the test chamber continues to be compensated.

6. At the end of the test cycle, the arc blowtorch combustion test automatically stops.

7. During the spray test, the particle size and intensity of the water mist can be set in the software as required.

8. After the test cycle is completed, all heating controls in the test chamber can be manually stopped. After the temperature drops below 50°C, the heating power supply is cut off.

9. During the test, if you do not need to measure real-time temperature and humidity, you can manually stop the collection of temperature and humidity signals.

10. If the computer stops working due to a power outage or other reasons and then restarts, you need to reset various parameters in the software.